|
You've seen that Synapse SNAP modules are
cool, but how to play with them? The SN171 Protoboard lets you plug
your Synapse module into it, and tap it via a RS-232 port and external
power. The Protoboard also lets you isolate all the pins from acting as
peripherals, so you have complete access to your test module.
The Protoboard is also a convenient way to
create a SNAP Bridge for connecting to
Portal or a SNAPconnect software.
Protoboard features:
- Compatible with all Synapse RF Engine modules.
- RS-232 port with full hardware flow control (UART1) fully
jumper selectable, or can be completely
“removed” from system.
- 2 status LEDs, yellow (GPIO2) and green (GPIO1)
(can be disabled by
jumper for low power usage)
- Push-button switch, can be jumpered to Reset,
GPIO5, or disabled.
- Battery connector (2.7~3.4V) or power regulator (5-9VDC,
standard 2.1mm barrel jack tip-positive) option.
- Multiple tapping capability via terminal blocks or pin
headers:
- Terminal blocks bring out all RF Engine pins and Vext
(supply power).
- 2x12, 2mm pitch header for ribbon cable access to all RF
Engine pins.
- Overall size of 2.95" x 2.625:
Note: SNAP RF module not included
|
